HoldTight102 ONE PRODUCT - TWO PURPOSES

Blastquip stock HoldTight 102 which prevents flash rusting of wet abrasive and water-blasting iron and steel surfaces and of dry blasted surfaces in a pressurised wash down.  This product effectively removes all salts, including Chlorides, sulfates, nitrates and other contaminants including oil, grease and blast residues.  It is approved by most major coating suppliers for use with coatings. Holdtight102 is an ideal solution to remove residue created while sodablasting and clean the surface ready for coating.

Features:

• Soluble in water
• Non Hazardous
• Non Toxic
• Biodegradable
• Acid Free
• Non Flammable
• Leaves No Residue
• Product chemistry approved for food grade service

Frequently Asked Questions:

Q. Whats the mix ratio (water to HoldTight®102) for a 48-120 Hour flash-free window and removal of salts, grease and other contaminants?

A. For Wet or Water Abrasive Blasting 0 For most applications 100:1 works fine. Where surface or air contamination or humidity are exceptionally high, 50:1 may be necessary to achieve the desired results

Why Use Holdtight ®102?

• A cost effective alternative to single purpose. multistep salt removal products
• A Coating friendly and effective alternative to old fashioned methods
• Experience and the data to back the product up

When Salts are a problem, it is a cost effective solution and reliable.  If Flash Rust is an issue it is THE answer. Cost Conscious? Check out the dilution ratios. If coating is a concern ask any well known coating supplier and compare to other products; no nitrates, no phosphates, no solvents, no film, no residue, non-acidic, neutral pH when applied.

Blastquip stock a large range of sandblasting equipment in New Zealand as well as a large range of coating equipment and inspection instruments